The current and residual value of superphosphate for lupins grown in rotation with oats and wheat on a deep sandy soil

In a field experiment on a deep pale-yellow sand in a 600 mm per annum rainfall Mediterranean environment of south-western Australia, six levels of phosphorus (P) as superphosphate (O up to 546 kg P ha^–1) were applied once only, to the soil surface, before sowing lupins (Lupinus angustifolius). The lupins were grown in a continuous arable cropping rotation with, in successive years, oats (Avena sativa), wheat (Triticum aestivum), lupins. Five such rotations were started in the experiment from 1985 to 1989. The experiment continued until the end of 1990.The relationship between lupin seed (grain) yields and the level of P applied was measured in the year of P application for five successive years (1985 to 1989). The relationship had the same general form but it varied between years, largely due to different maximum yields (yield plateaux) in each year.The residual value of superphosphate applied three years previously was measured for lupins on two occasions (1988 and 1989) relative to superphosphate applied in the current year. The residual values was different in the two years. The superphosphate applied three years previously was about 30% as effective as freshly applied superphosphate in 1988, and 12% as effective in 1989.At each harvest, the relationship between grain yield and the P concentration in the grain differed for different species. However, for each species at each harvest, the relationship was similar regardless of when the P was applied in the previous years. Thus each species had the same internal efficiency of P use curve, and yields varied only with P concentration in tissue.Bicarbonate-extractable soil P was determined on soil samples taken in mid-July of 1989 and 1990. These soil test values were related to grain yields at harvest. The relationship between yield and soil test values had the same general form but varied for different species within years and for each species between years. It also varied for each species within years depending on the year the P was applied.     

铁电体尺寸对其开关特性的影响

应用铁电体极化反转的Orihara Ishibashi理论 ,讨论了圆形铁电薄膜和球形铁电体的开关电流以及开关时间对系统尺寸的依赖性。数值计算表明 ,不论是二维还是三维铁电系统 ,其铁电畴反转过程中产生的开关电流都随系统尺寸减少而下降 ,开关时间随系统尺寸减少而缩短     

Superplastic behaviour of Ti-48at.%Al two-phase titanium aluminide compacts made from mechanically alloyed powder

An HIP compact of MA-processed powder having a nominal composition of Ti-48at.% Al was produced. The compact consisted of a large amount of TiAl(λ) and a small amount of Ti₃Al (₂), in a completely ultra-fine equiaxed grain structure. This two-phase compact showed typical superplastic deformation behaviour. A maximum elongation of 550% was obtained. A strain exponent, n = 2, and grain size exponent, p = 2, were determined from the results of a strain-rate-change test and a creep test at constant initial stress using samples having various grain sizes, respectively. The activation energy for creep, Q_c at constant stress was calculated to be 350 kJ/mole. It is concluded that the superplastic deformation mechanism of the material under study is grain boundary sliding controlled by lattice diffusion in the TiAl phase.     

铣槽专用夹具设计

从零件的几何形状 ,配合要求入手 ,设计零件铣槽的专用夹具     

二钼酸铵(ADM)非团聚晶体的生成试验

探讨了二钼酸铵非团聚晶体生成的机理及制取新工艺。采取该工艺制取的ADM费氏粒度（Fsss)约30μm，激光粒度分布d0.5为370μm，松装比达1.37/cm^3。     

影响凹印铜金粉印金光泽度的主要因素

在研究国内外铜金粉的微观形貌、厚度、水面遮盖率、定向排列、光泽度和粒度分布的基础上，分析了影响凹印铜金粉印金光泽度的主要因素。结果表明，国产铜金粉颗粒级差大、细小颗粒所占比例过多、金属片太厚、水面遮盖率小、定向排列不好等是影响国产铜金粉印金光泽度的主要因素。     

某含砷浮选金精矿的细菌氧化预处理-氰化提金试验研究

云南省某含砷难浸金精矿，常规氰化金浸出率仅为26．17％，通过采用细菌氧化预处理后，金浸出率达到98．25％，获得了非常理想的试验指标。     

Mechanism for the Peritectic Reaction and Growth of Aligned Grains in YBa2Cu3O6+x

It is experimentally observed that the peritectic reaction, 211 + liquid → 123, can be driven essentially to completion in 1 h at an undercooling of only ∽30°C. The kinetic data, together with the observed microstructures, are inconsistent with the normal mechanism of the peritectic reaction. It is proposed that the mechanism of the reaction involves dissolution of 211 particles into the liquid and precipitation of solid 123. The aligned grain structure is explained through sympathetic nucleation of new 123 grains on existing grains.     

Effect of water deficit on yield and protein content in pearl millet grains

Seventy-two pearl millet genotypes were water stressed at panicle development and grain filling stages. Neither grain yields, yield components, protein percent nor total protein per unit area were affected by water deficit during panicle development but protein content per grain was increased. When plants were water stressed during grain filling, grain yield, grains per unit area and 1000 grain weight were reduced, but grain protein percentage increased. Total protein per unit area was reduced primarily due to lower grain yield. The protein content per grain was unaffected by stress, suggesting that the apparent increase in protein percentage is due to reduced carbohydrate accumulation under stress.